Hall-research UVA-WP Manuel d'utilisateur télécharger pdf (Page 11)

Wallplate VGA and Audio on UTP Transmitter

Connect the remote monitor and speakers to the URA or another

compatible receiver unit (as shown above) and attach the power

supply to the receiver.

CAUTION

Before plugging in the remote monitor, verify that the AC line is properly wired and that a

protective ground (green) wire is established with NO potential difference between both the

sender and receiver locations. The splitter can tolerate up to 5 vPeak-Peak ground potential

between the two locations. Failure to ensure good grounding can result in erratic operation and

possible shock hazards or damage to your equipment.

2.5 Adjusting Cable Length Compensation

Compensation

ustment

Older Versions

Newer Versions

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Pas de commentaire

Hall-research UVA-WP Manuel d'utilisateur Page 11